Upgrade Stoves With Custom Stand Extensions

The Turbo I-D and Turbo II-D are now available with optional custom stainless steel stand extensions. Extensions are soldered by hand to stock stoves on a special-order basis. The stand extensions significantly improve stability especially with pots that are on the outer range of the stove’s capacity. This modification increases the stove weight by only 0.3 oz (9 gm). It’s also possible to have these extensions added to ANY Brasslite stove(s) you now own except the Turbo F (see bottom of page for directions).

Will the extensions allow the stove to nest inside your pot? The extensions are permanently attached and create a profile that will fit inside a pot that is at minimum 5 inches (13 cm) in diameter. The modified Turbo I-D and Turbo II-D will fit in both the Vargo 0.9 L and 1.3 L pots. However, the modified stoves will NOT fit inside any pot that is smaller than 5 inches in diameter. Adding the extensions is not necessary for pots with a base diameter below 5 inches. The height of the modified stoves is increased slightly over the unmodified versions.

Make payments with PayPal – it’s fast, free and secure!

Click button above to Upgrade the NEW Turbo stove(s) you JUST ORDERED with custom stainless steel stand extensions for $20.00. This is a custom order and requires additional shop time, since the extensions are soldered by hand. You’ll receive an email informing you of wait time when you place your order. if you’re concerned about wait time because of an upcoming trip, send an email first to aaron(at)brasslite(dot)com and ask for an approximate shipping date.

Sustainable Website Design - Custom WordPress Expertise - Serving Maine and the U.S.